A narrow brass line can frame a large stone panel or carry a pattern across a doorway. On a drawi…
A narrow brass line can frame a large stone panel or carry a pattern across a doorway. On a drawing, a straight run and a curved border may look equally simple. On the cutting list, the straight run needs an end-to-end length; the curved piece needs a radius and a length measured along the arc.
For brass patti, marble inlay and tile divider strips, start with the cross-section. A 4 mm visible line and a 12.7 mm visible line give very different proportions. Which face of the flat strip is exposed? A section through the floor answers that question more clearly than a plan view. It also shows the recess depth and the finish level of the surrounding stone.
For a circular brass inlay, measure along the centre of the strip. A full circle uses circumference; a partial arc needs its angle as well as its radius. Keep straight lengths, curved lengths and joint allowances separate so the installer can place joins where the layout and pattern allow.
Brushed and polished brass reflect light differently. Compare the finish beside the cut marble or timber, and show the brushing direction on pieces that meet at a corner. Brass alloy and temper matter where the strip must take a curve without kinking.
PRASHAANT STEEL & ALLOYS, a non-ferrous metal supplier, stockist and exporter in Gulalwadi, Mumbai, India, welcomes brass inlay strip enquiries from architects, flooring contractors, furniture makers and interior fit-out teams.